|
MT
Throttle bodies balancing procedure
|
|
All
bleed screws must be screwed fully in.
1.
With engine running, match the butterfly from each pair of bodies
that has the highest vaccum reading to the highest of the two using
the lever arm adjustment between the bodies. This will balance the
bodies together. 2. Then unscrew the bleed screw from the butterfly with the lowest vaccum reading on each pair of bodies to match the reading from no. 1 |
|
Example
|
|
|
|
Adjust
no.1 from 6Kp/hr to read same as no.4 @ 8 Kp/hr & then using bleed
screws adjust no.2 & no.3 to read 8 Kp/hr
|
